Micronix PV-1800 offers a unique combination of GSM/GPRS mobile communication with integrated I/O and RS232 channels provides a cost-effective and space saving PC/104 solution for GSM/GPRS applications.
Micronix PV-1800 is a low-power GSM/Cellular modem using Sony Ericcsson’s GM47 dual band (900/1800MHz) cellular engine. The PV-1800 can be controlled by AT commands and is fully compatible with the AT command set. PV-1800 has 8 isolated analogue (0-10V) inputs, enab-ling data acquisition directly on-board. 8 digital inputs and 7 digital outputs (all opto-isolated) allowing the user to control auxiliary equipment. Events can be reported thru the SMS feature on the GSM modem. The Micronix PV-1800 also includes 1 complete 16C550 compatible serial port for serial expansion. The board can be configured for any standard COM port address. An on-board SIM card socket provides a fast and reliable integration of your SIM card without any cabling or customisation. A free of charge software lets you easily install and configure the SIM card, including PIN code setting. Micronix PV-1800 represents the latest development within GSM technology and holds all the necessary approvals (R&TTE and GCF), thus PV-1800 is recommended for all new designs. The PV- 1800 is ideal for all PC/104 based data logging and alarm systems. The PV-1800 withstands extended temperatures, shock and vibration of mobile equipment More for lessMicronix PV-1800S is approximately 25% lower priced than other GSM/GPRS PC/104 modems and provides more features than any other PC/104 GSM/GPRS modem available on this form factor. MICRONIX PV-1800 Features:
- Dual-band EGSM900/GSM1800
- Data,Voice,SMS and Fax
- Control via AT commands
- Integrated I/O:
- 8 Isolated analogue inputs (0-10V), 12-bit
- 8 Digital inputs, opto-isolated
- 7 Digital outputs, opto-isolated
- 1xRS232 port (standard COM port)
- Low power consumption
- RoHS Compliant
- Wide temperature range: -20° to +70°C
- Low cost
Versions & Ordering codes
|
Feature |
| Model no. |
GSM/GPRS modem |
Power supply |
Analogue inputs |
Digital I/O |
Serial ports |
Simple I/O |
| PV-1800AS |
• |
None |
8AI, isolated |
8DI, 7DO, opto-isolated |
1xRS232 |
3AI,1AO, 4DIO |
| Power supply: |
| Input voltage (nominal) |
8-27Vdc. |
| Output voltage |
35Vdc |
| External load |
Up to 4 A, depending on configuration and thermal conditions. |
| UPS interface: |
| 4 pins in CN7 |
Run/stop, AUX1,AUX2, AUX3 (factory use only). |
| GSM-modem: |
| Modem type |
GM47 (SonyEricsson). |
| SIM card interface |
3V or 5V |
| Frequncy range |
EGSM 900 MHz |
1800 MHz (Dual Band) |
| Maximum RF output power |
2W |
1W |
| Antenna impedance |
50? |
| Antenna connector type |
MMCX RF connector |
| Supported I/Os (using AT commands) |
Available in 10pin connector |
| 3 Analogue inputs * |
8 bit, 0 - 2.75V |
| 1 Analogue outpit * |
8 bit, 0-2.475V |
| 4 general purpose digital inputs * |
0 - 2.75V |
| COM ports: |
| Number of ports |
Two, one used for GSM modem |
| Addressing range |
2C8h, 2D8h, 2E8h, 2F8h, 3D8h, 3E8h, 3F8h, disabled |
| IRQs supported |
3, 4, 5, 7, 9, 10, 11, 12, 15 |
| Connector |
Port 2 available in 10pin box header. |
| Analogue inputs: |
| Resolution |
12 bit |
| Inputs |
8 ch. single ended or 4 ch. differential - one common |
| Isolation |
1kV, 1 minute |
| Input range configurations (all unipolar) |
8 x 0-2.5V (default) or 8 x 0-5V or 8 x 0-10V or 8 x 0-20mA or 4 x 0-20mA + 4 x 0-2.5V
|
| Input impedance |
1M? (default). |
| Accuracy |
0.5% of FSR, ±3 LSB (default) |
| Conversion time |
11µ |
| Digital inputs: |
| Number of channels |
8 isolated, one common ground |
| Digital logic levels |
0 - 24V, non-polarity, Input low voltage: 0 - 1.5V Input high voltage: 10 - 24V |
| Max input voltage |
30V, current limiting resistor = 3.32kohm / 250mW |
| Counter input |
DI0 can act as a 16-bit up-counter by counting positive og negative edges (configurable) DI0 and DI1 can act as a 16-bit quadrature counter. |
| Max counting rate |
10kHz |
| Connector type |
10 pin box header |
| Digital outputs: |
| Number of channels |
7 isolated PNP outputs |
| Max load current |
0.5Adc, load current external delivered, total current must not exceed 1.5Adc. |
| Max voltage |
30Vdc |
| Protection |
Snubber diode at each output |
| Connector type |
10 pin box header |
| Environmental specifications: |
| Operating temperature |
-20o to + 70oC |
| Storage temperature |
-40o to + 85oC |
| Humidity |
20 to 90% non-condesing |
| Cyclic humidity |
ETS 300 019-2-5 or equal |
| Vibration |
10-1000 Hz Sinus and random @ 1-1,5G RMS |
| Sustained vibration |
EN 60068-2-34 & EN 60068-2-36 |
| Shock |
IEC 60068-2-27 & IEC 60068-02-29 |
| Size (W x L x H) |
90 x 96 x 14mm -see next page |
| Weight |
116g (excl. packaging) |
* For details refer to SonyEricsson's documentation:
|